T0001???

[SMARKSTHESPOT]

I keep having a problem where Mastercam x4 will change my tool numbers to T00 on the operation manager page i.e. T0101 will become T0001 T0800 will become T0008. If I reselect the Parameter for the op I am using that tool on and open up the tool on the Toolpath Parameter page it will say the tool number is 1 offset numbers are 1 as well. Then if I select OK on the tool parameters then OK on the toolpath parameter they will go back to T0101 on the operations manager. Its only a problem if I dont catch them before I post them out. In which case it will post as T0001. It only seems to want to do this on lathe and not on every tool.