WCS and Verify

[modeler]

I am just starting to create my own WCS and when I verify my toolpath, the block is not orientated in the set WCS. I'm not sure how to go about reorientating my block.

[Guest CNC Apps Guy 1]

Go into your job setup and pick up the corners again. It's probably oriented for your first WCS right?

[ProductDevelopmentGuy]

Support of the WCS in 'Verify' is one of the enhancements to be found in the upcoming V9.1.

PDG

 

[ 09-17-2002, 12:27 PM: Message edited by: ProductDevelopmentGuy ]

[Roger Peterson]

Currently if you want to verify toolpaths referencing a wcs other than top there are a few steps. first go into your wcs and hit all off. Next go into job setup and recreate your stock. Now go into verify's config window and pick true solid using a wireframe tool. You will see a 3D representation of your part, turbo is not an option in V9.0 sp1.

 

hope this helps