Help with chaining solids. No response trying to change start point

[Bill K]

In regards to chaining a solid contour loop. When I try to change the start point of the chain with either the backup or forward buttons, there is no response. What am I doing wrong? v8.1.1 We did just change the OS to 2000 pro.

I might add, being new to solids, this the first time that I have tried to do this.

[Jean-Simon]

I really don't know what's wrong because i do exactly what you explained and sorry but i did worked and we run xp pro. Maybe rebooth or try on another file to make sure it's not the file wich is corrupted.

 

Good luck!

[David S]

I don't think Change Start Point feature is available for the solid contour. You might get it in MasterCam V10.

[cadcam]

David is correct but as you are picking then the arrow shows the direction they also offer there to to go backward or forward before you finish.

[David S]

Jay, thank you for covering me up!

 

Bill, in your case, try to reinstall your MasterCam V8.1.1 and download and install latest SP for V8.1.1.

 

Hope this will help.