dwell repeating

[nickz]

I searched the forum for any related items first and haven't found anything. Question is: How do I remove the repeating dwell words from each XY location, the P address is only needed once within the canned cycle line and that will take care of all the XY's until G80. I looked through the post file(mpfan.pst) for a quick fix....don't see it yet. If anyone is familiar with this situation (looks simple, but I'm stumped) please advise. Thanks.

example code of what's happening.

 

N310M6T31(SAE- 6, PORT C-BORE)

M01

S1000M3

T32

G00G90G54.1P1

X-64.417Y24.728

G43H31Z25.M8

G98G82Z-24.8R2.5P2000F250.

X-68.958Y2.408P2000

X-65.985Y-20.174P2000

X-55.822Y-40.557P2000

X54.863Y-1.437P2000

X67.365Y14.934P2000

X49.116Y24.488P2000

X52.468Y44.812P2000

G80

M9

 

[Allan Brown]

Concentrate on the pdrill_2 post block. You are looking for *dwell or pdwell - depends on the post. You could also have dwell formatted with a non-modal format statement.

[nickz]

Yes, you are correct sir.

The pdrill_2 postblock is for additional points and I blocked out the dwell and the output does not repeat, its only in the canned cycle line, which is taken care of by the pdrill postblock. Thank you once again.

N310M6T31(SAE- 6, PORT C-BORE)

M01

S1000M3

T32

G00G90G54.1P1

X-64.417Y24.728

G43H31Z25.M8

G98G82Z-24.8R2.5P2000F250.

X-68.958Y2.408

X-65.985Y-20.174

X-55.822Y-40.557

X54.863Y-1.437

X67.365Y14.934

X49.116Y24.488

X52.468Y44.812

G80

M9

[This message has been edited by nickz (edited 12-06-2000).]