MP-Master Okuma 4 Axis Post

[Mick]

Hi there

 

I was about to go into work to do a 4 axis job, and I realised I dont have the MPMaster 4Axis Okuma post for Version 8. We did have it, but a hard drive crash lost it, and we didn't have a backup of that particular post/ Does anyone have that Post handy? I need it very soon, and its been removed from the post page. (My dealer isn't avaliable weekends)

If so, can anyone please put it on the ftp site or email it to me? [email protected]

 

Thanks,

 

Mick

[Guest]

The mpmaster for V8 is on this web site. Here is a link to it.

 

mpmaster v8

[Mick]

Thanks Mark, but that is MPMaster 4 Axis for a Fanuc control. Inhouse Solutions did have both a V8 and V9 Okuma-specific 4 axis post on the same site, but they've taken it off, and request that you contact your local reseller to obtain it. I'd do that, but its the weekend, and my reseller can't be contacted :/. I might try and alter the V9 one to try and mark it work with V9.

Okumas use an M15/M16 to define the rotation direction of the rotary axis, and the MpMaster does this flawlessly.

Thanks again for the response though