MC9 WIRE

[chad fisher]

When using mcam wire 9 i use "rough with tab" then skim. My question is how come it wants to go back to the start position after tab cut instead of just reversing. I think in 8 it would do this. My contour is not closed. Any ideas i think i have tried every toggle on the cuts page and no luck. Thanks in advance, Chad

[KG]

hi chad

try this set your tab width.set your rough & skim

cut before tab to 2

number of tabs 0

 

number of skim cut after tab to 0

 

check all cuts together

 

output tab after last cut.

[chad fisher]

Thanks KG, but it didnt seem to work. Ill give this example of what i want to do. Lets take a

1 dia hole, STCW in center, cut dia just short of maybe .04, stop with M0, then finish tab cut then

reverse "with out wanting to move back to center" taking skim cut. Is this possible??? Or am i just really blind and missing something? Thanks in advance, Chad