Is it just me or......

[Nominal]

There seems to be some problems with the graphical setup sheet in nc utils V9. First of all I hardly ever crash this p4 2gig beast unless I try to create a setup sheet. Then it crashes about as much as it works. So I've gotten used to saving just before I attempt to make a setup sheet. I'm thinking that the code in this area of V9 must be weak. Further evidence of this is the fact that any manual entry ops end the setup sheet prematurely. Anybody else have problems with this part of MC?

[M.I.H.A]

I had the same problem.Later on i upgraded printer drivers and now works fine.

[PBpaul]

I had that happen and what fixed it for me was to go to Screen, then Configure, then be sure "Use Windows Driver" box is checked. Of course, I'm assuming you are using a Windows default printer.

 

Paul