Rotary toolpath

[mcmoney]

Hi I have vmc with 4th axis

I never programed that with mc

how do you make a simple toolpaht with that

 

in mc9 folder test rotary.mc9

 

thank you

[Jean-Simon]

Hi MC, I had a look at your file and it would only be possible to machine the four faces of your block. For the radiuses you would need a ballor bull nose but it would leave a radius between faces and that would be 4 axis simultaneous (a little more complicated) to program than positionning.If you want me to program the flats, let me know.

 

Simon

[David S]

1.) I saw someone connecting four or more .NC files with C0, C90, C180 and C360…. Make sure your Z sets on the center of your turntable.

 

2.) You may use ROTARY 4 AXIS, Axial Cut to do it.

 

Do you have 4-axis post processor? You need it.

 

Hope this will help some.

[mcmoney]

Merci Jean-Simon

 

Mon français est bien meilleur que mon anglais hehe

 

jai une full 4 axes comme machine et jaimerais avoir des coins sharp comme le dessin

jai réussi a faire de koi de pas pire mais jaimerais le faire en une seul coupe et sans que l'outil lève si ca ce fais

 

merci

[David S]

quote:

---

Merci Jean-Simon

 

Mon français est bien meilleur que mon anglais hehe

 

jai une full 4 axes comme machine et jaimerais avoir des coins sharp comme le dessin

jai réussi a faire de koi de pas pire mais jaimerais le faire en une seul coupe et sans que l'outil lève si ca ce fais

 

merci

---

Yeh!! That is great!!!!

 

mcmoney, you can make money with your new English. Is it French?

I am sure you want to say someting. Dose Mr. Merci Jean-Simon understand you?