Multicam Router

[Chris Kozell]

Hello all! Any of you guys out there running a multicam router series 3-205? In the post I am running in a middle of the contour toolpath it switches to a rapid move. I am wondering if its the m12 or m22. Below is a sample of the code.

 

M90

G90

G75

G97 S18000

G00 T1

G00 Z-1.

G00 X.25 Y-.25

G01 Z.1 F.83

X8.2706

G02 X8.5206 Y-.5 I8.2706 J-.5

G01 Y-3.357

G02 X8.2706 Y-3.607 I8.2706 J-3.357

G01 X.25

G02 X0. Y-3.357 I.25 J-3.357

G01 Y-.5

G02 X.25 Y-.25 I.25 J-.5

G01 Z-1.

M12

G00 X8.7706

G01 Z.1 F.83

X13.2652

G02 X13.5152 Y-.5 I13.2652 J-.5

G01 Y-3.357

G02 X13.2652 Y-3.607 I13.2652 J-3.357

G01 X8.7706

G02 X8.5206 Y-3.357 I8.7706 J-3.357

G01 Y-.5

G02 X8.7706 Y-.25 I8.7706 J-.5

G01 Z-1.

G00 X13.7652

M22

G01 Z.

 

Thanks for any help.

[Chris Kozell]

Ok, i think i got it. No m12 in the first part of the program. the cause is the customer has clearance and retract checked off. YOU MUST HAVE THESE ON!!!!

[Trevor Bailey]

what post are you running? i have a dialed in post for their latest control that supports rigid tapping. i will be adding a couple of other goodies later on as the customer "learns" his machine.

[MadPickinSkills]

On Heian routers, M12 is spindle up and M22 is spindle down. You may be using the wrong post for your machine. Change M12 to G0 Z1. and M22 to G01 Z-1. F50. You can change the F50. to whatever feedrate you're comfortable with.

[tonyc]

The G00 is telling it to be a rapid move. Change it to a G01 then you can control your feed rate with F50. to whatever feedrate you're comfortable with.I hope this is helpful