9.1 File changed save

[gagdorny]

Hello everyone I have been reading this form for about a year but this is my first post. I have just updated to 9.1 and have a problem. When I open a file I get the message "file has changed do you want to save". If I answer no everything is ok, but if you answer yes it wipes out the file. The only way I have fix it is to uncheck the box in the config set up that says prompt on exit if file has changed. This is the only problem I have had so far. ps. I upgraded to mastercam 8.1 from surfcam and couldn't be happer. [email protected] or [email protected]

[Rekd™]

Wow. Haven't seen that before. You're getting the error when you OPEN a file?

 

'Rekd teh Programming is Half Skill and Half Black Art

[Toolfab]

You should get that message on the save function, because all of your 8.1 files neede to be converted to 9.1, but to say yes and have it wiped out

 

If you start Mcam, and with nothin previously loaded and then do your inital file/get/8.1 or whatever, does it do it then??

 

 

BTW

quote:

---

'Rekd teh Programming is Half Skill and Half Black Art

---

BRILLIANT

[gagdorny]

The files I'm opening are 9sp1. Its a full clean load and even after I modify the file and resave it in 9.1 it still asked that question. I can work around it but it would be nice to fix it. If I uncheck the box for the notifacating on closing I no longer get it on opening. Thanks for reading my post.