Question about MC 9.1...

[Ronan]

I would like to that everyone for the helpful answers to my last post.I have another question.In MC 9.1 whenever I skim the outside of a block (after roughing the block then cutting a cavity)It wants to thread and start the 1st skim pass at the lead out and not the lead in (where my thread hole is located).I've tried using the origins/wcs option from the wire parameters page to thread at the lead in but it insists on threading and starting the first skim at the lead out.It would work if I picked the one way option in the general page but that means it cuts,rapid moves and rethreads at every pass.Is there a way of using the reverse option and having it skim all passes from the lead in uninterupted ? I appreciate any help I can get...Thanks...Ronan,