Outputting Manual Entry Comments

[Jimmy Wakeford from Barefoot CNC]

Had a customer call in today that was having problems with outputting manual entry comments. If the manul entry was posted by itself or first, then it would output. If it was after a toolpath operation it would not output. :headscratch:

 

I tried with the default posts and had the same problem. After trying every trick I knew to try and get them to output I finally added this to the post to get manual entry to work properly:

 

pcomment0$       #Comment from manual entry (must call pcomment2)
     pcomment2 #Required if doing boolean 'if' logic testing!

 

HTH

[Jimmy Wakeford from Barefoot CNC]

Had to add a line so if manual entry is the first op it comes out after pheader$:

 

pcomment0$       #Comment from manual entry (must call pcomment2)
     if miscopflag = zero, pheader$
     pcomment2 #Required if doing boolean 'if' logic testing!