Change Recognition Tollerance?

[Greg_J]

Hey guys,

Is there a way to set the tolerance for change recognition? For example you can set the tolerance to .0001 for fussy parts or .005 for less important parts, so anything less then set value will be skipped?

 

Thanks,

Greg

[Greg_J]

Maybe Change Recognition links to one of the tollerances under the Configuration -> Tollerances tab?

 

 

Any one? Any one?

 

Bueller, Bueller?

[Guest]

NO Tolerance setting AFAIK Greg

 

it's the same or it's not, which is likely controlled by an "inside" tolerance setting that is not able to be changed

[Greg_J]

Darn.

 

When I was picking unique to incoming it was showing things on the new model that the engineers didn't even change, I was hoping to speed up the process and avoiding unnessasary regens.

 

Oh well,

 

Yet againg you've been a big help.

[Guest]

Greg,

 

I would be wary, if they went dirty, they're different, the question is by how much?

[JoeyW]

Greg,

 

Change recongnition uses the system tolerance in your config file. Changing the system tolerance to .005" will allow change recognition to ignore any change smaller than .005". I would recommend creating a special config file just for doing this, as changing your system tolerance will also change all the other tolerances (eg. chain tolerance, etc). Having 2 or 3 config files will allow you to switch between different tolerances easily.

[Greg_J]

John,

When I measure them there is no change greater then .0001, the old and new model measure the same.

 

Joey,

Thanks for the info, that's just what I was looking to know.