Forcing an M05 at toolchange

[Mr. M]

I am trying to force a M05 before each toolchange on our post for our Hurco mills and I think I found where it needs to be, now I just need to find out what to put there

pstop      # Stop routine
          pretract
          pcom_moveb
          if mi10$=one, n$, *sm00, e$
          sav_absinc = absinc$
          if wcstype > one, absinc$ = zero
          if lock_codes = 1 & not(index) & rot_on_x, pbld, n$, *sunlock, "(UNLOCK)", e$
          pbld, n$, pwcs, e$
          pcan1, pbld, n$, *sgcode, *sgabsinc, pfxout, pfyout,
            pfcout, *speed, *spindle, pgear, strcantext, e$
          if lock_codes = 1 & not(index) & rot_on_x & cuttype = 0, pbld, n$, *slock, "(LOCK)", e$
          pbld, n$, "G43", *tlngno$, pfzout, scoolant, next_tool$, e$
          sav_coolant = coolant$
          if coolant$ = 1, sm09 = sm09_0
          if coolant$ = 2, sm09 = sm09_1
          if coolant$ = 3, sm09 = sm09_2
          absinc$ = sav_absinc

I believe it needs to be in this section here, could anyone point me in the correct direction as to what code I need there?

Thank you!

[K2csq7]

I would start by putting it right at the top, put in this line exactly as you see it, just keep the indentation the same as the other lines in the postblock (think your supposed to start in column 7)

 

pbld, n$, "M05", e$

 

See what that gives you...

[Mr. M]

My reseller helped me out. In the pretract post block it had [if eof, *sm05] and we changed that to only *sm05 and that did the trick!