Stock Setup Error

[Matt @ Dominion Cad/Cam]

I keep getting there error after reinstalling and deleting the registery. I can not track it down. This pops up when I go to the Stock Setup under properties. Anybody have an idea.

First Error Message.bmp

[NOTW Programmer]

You machine group propertis might have a stock setup for STL and the file it points to is non-existent.

[Guest]

Go into your settings >> config

 

Verify >> Verify settings and change it from file to box.

 

 

Save and restart.

 

This WILL pop that error

[Guest]

If that's not it, I might suggest going into the Op Defaults and see if there is a stock setup in there. This doesn't seem to put that error up though, so I am banking on the first solution

 

It should be Rectangle as default

[Matt @ Dominion Cad/Cam]

Thanks John, The first solution worked. Bet my head against the wall all day and still could figure it it.