Manual Entry in Active Reports

[sir Camalot]

Does anyone know or is there a way to get Active Reports to output the Manual Entry that is created and shown in the operations manager?

[headhunter]

You should be able to locate the manual entry section in the menu on the right side of the Designer then drag and drop it where you need.

 

 

 

 

 

Does anyone know or is there a way to get Active Reports to output the Manual Entry that is created and shown in the operations manager?

crop.bmp

[NOTW Programmer]

You should be able to locate the manual entry section in the menu on the right side of the Designer then drag and drop it where you need.

Nice trick. Hey by the way you can convert your images to PNG and save some space since we are limited here.

[sir Camalot]

Will that treat the entry like a toolpath and automatically show in the correct spot or is this a mod to the report that will show in every report whether it is used or not? I use this to place notes that the operator needs to see at the right point in the setup sheet. I think this would be a nice feature if it isn't setup that way now. I just figured if it was a manual entry that the report would capture it like a toolpath entry. Is there a reason that it doesn't show like any other toolpath? Thanks for the input.

[headhunter]

Wow, will do on the .png conversion. That's a lot bigger than I expected....

 

 

Yeah it will input the comment where ever you have it in the op manager. The way I set my setup sheet up was to use the manual entry field at the end of all the toolpaths. I'd put all my setup notes in a manual entry, but use the comments in the toolpath parameter page for any tool-specific info I needed.

 

 

 

Will that treat the entry like a toolpath and automatically show in the correct spot or is this a mod to the report that will show in every report whether it is used or not? I use this to place notes that the operator needs to see at the right point in the setup sheet. I think this would be a nice feature if it isn't setup that way now. I just figured if it was a manual entry that the report would capture it like a toolpath entry. Is there a reason that it doesn't show like any other toolpath? Thanks for the input.

[sir Camalot]

Thanks headhunter. I will try this and see how it works.