Multi Post

[connormac]

I am using a post that was written for 6 machines. I can make it use sub's with different work offsets. But if I try to do a progressive operation the post won't put in a G55 offset for vise no. 2. I put in a 2 on the T/C plane page and it shows up with work offset #2 on that operation on the operation page. any help would be helpful.

[CNCme]

Good Day,

 

Do you have a MC version...V8, V9, and who

wrote this 6 mach. post, and has the post been

Updated...? Or what Ver. Post...?

 

Tony G

Unemployed Senior Programmer

N.E Massachusetts - Southern New Hampshire

_________________________________________

End mills and tooling are like The "AMMO"

And coolant and chips are like the enemy

Under your boots as you advance in the

Manufacturing Battle.

_________________________________________

[connormac]

thanks for the reply. using version 9.0. post was written for us by dealer about a year ago. before the last programmer was let go. It has been updated for version 9. I think the last programmer might not have left use the latest fixed version.

[CNCme]

Good Day,

 

Even if the post was updated it might have been

an older post version. Pre V8 or V9. Open the

post in the Editor, and check the post version.

and also get the add-ons from patches tab above.

HTH

 

 

Tony G

Unemployed Senior Programmer

N.E Massachusetts - Southern New Hampshire

_________________________________________

End mills and tooling are like The "AMMO"

And coolant and chips are like the enemy

Under your boots as you advance in the

Manufacturing Battle.

_________________________________________

 

[ 07-31-2003, 07:26 PM: Message edited by: CNCme ]

[connormac]

The post Version is V8.xx and has been updated to V9. have all the patches also. I think it is just something small because the old programmer was lazy and would not have manually fixed all the programs. Think he fixed the post originally but when he left took the fixed version with him.