G and M codes for Robocut

[Larry Metzler]

I am trying my best to edit a post for a Fanuc Robocut wire EDM. I know next to nothing

about wire machines. When milling I have no problem. I am hoping some one on this forum

can steer me to a location,(or forward to me) a site where I can get a list of codes used

on a wire. Thanks

[Del.]

I am trying my best to edit a post for a Fanuc Robocut wire EDM. I know next to nothing

about wire machines. When milling I have no problem. I am hoping some one on this forum

can steer me to a location,(or forward to me) a site where I can get a list of codes used

on a wire. Thanks

 

 

Ill send you those codes Larry. Send me your email address.

[Larry Metzler]

Ill send you those codes Larry. Send me your email address.

 

Thanks Very Much Del,

 

[email protected]

[Del.]

Thanks Very Much Del,

 

[email protected]

 

 

Let me know if you are able to open those up. I may need to send you the letter addresses also if you need them. Like the I AND J, etc.

[Larry Metzler]

Del, Came through with no files or attachments to open.

Regards,

Larry

[Del.]

Now see if they came through Larry.

[wesright]

Hello, can  I get a copy of these codes as well? Alternatively, is there a link available or is the list out there online somewhere?

I'd have thought that Fanuc would make this list digitally available but no such luck. Same deal with the Cutting Technology Values unfortunately. I have the Cutting Tech Values in several inch thick manuals but no digital copy.