Toolpath Editor

[Rotary Ninja]

I have a parallel pocket toolpath cutting 4 pockets. The first -X- move after helixing down into the pocket is basically a slot move cutting the full width of the endmill. I used the "Toolpath Editor" to edit the toolpath to slow the feed down on each of these pockets just for the first -X- move through the pocket since it is a rather aggresive feed and depth of cut. Since there are 5 depth cuts per pocket that was 20 points that I slowed the feedrate down, then 20 more that I sped it back up after this initial slot. After posting I found that the coolant was turned off at each of these edited points and never turned back on. Is there something I am doing wrong?

[Justin Beebe at Folsom Tool]

When I use the toolpath editor I find that the coolant turns off unless you turn it on when you edit your first point even if you had it turned on in your toolpath. I'm not sure if this is a bug but thats how I get it to stay on.

[Rotary Ninja]

Yeah I figured that much out after I had already edited the 40 points. I then had to edit them again. Was just wondering if there is a setting to correct this?