MPLFAN question

[Thee Dragracer1951]

I'm back in the dark ages using X3, so bear with me. I am editing my MPLFAN post so as to output R values as opposed to Is and K's

What post value do I change?

I would have thought it would have been arctype$ but that isn't doing it.

Any help would be most appreciated.

This is to get somewhat useable code for a Hardinge turett lathe with an Analam 4200T control

[NOTW Programmer]

Correct me if im wrong but cant you turn a setting on in the CD to take care of these far easier than editing the POST.

[Bryan Johnson]

Yes. This variable is set from the Control Definition.

See values on the arc settings tab.

 

[Thee Dragracer1951]

You guys are Awesome

Thanks!!