Cimco Numbering

[k turk]

I am setting up a new workstation for an employee. Our machine posts an error for a line number greater than 6 places (ex - N1000000). On our other stations, I've set the numbering to recycle at N10000 . . . . . but this was quite some time ago. Seems like it must have been somewhere in the Global Setup window but I can't find where I this is done. Am I in the right neighborhood?

 

Thanks

[Guest]

Global settings >> Block numbers

 

 

Set the Restart at every value

[k turk]

That is what I thought, but putting values here hasn't effected the numbering. I've also looked at our setup which works and there are no values in that window. . . . . . . . . . ?

[Guest]

Is it happening if you renumber in Cimco or is it happening just as you post.

 

If your control def posts out numbers, you need to renumber in Cimco, then it will setup what you have defined but upon posting the the file it accepts what is output

 

You may need to look at your control def and set the maximum sequence value in there

[k turk]

yep, it is in the control definition.

 

thanks