PATH CONTROL

[jbelle7435]

WIRE

 

I am still having trouble controlling the path the wire starts at. I got the circle down and thats working fine. Now If I had a square or linear path to travel when I finish up chaning it decides to go from the center to one of the corners of the cut and I can not have that(Pre-determined angle). I need to control from the center point to where the next location will be and when doing so it still decides to go to that corner or the cut and start there from the 0,0.

[Del.]

Break one side of the square at the mid point.

Select chain

select thread point

select line that is broken but select it in a way it chains in the direction you want

[Guest]

Training