Rigid tapping cycle for Anilam 6000 M

[daveb56]

I am looking for a rigid tapping cycle for an Anilam 6000M control on a Fryer HR 60 Horizontal mill.

Have tried Fadel & Fanuc posts and nothing seems to work. Does Anilam need different info than any one else.

Any help wold be greatly appreciated

 

THANKS.

[Guest MTB Technical Services]

Here you go.

It doesn't have a Rigid Tap cycle per se but you will be able to get your tapping working.

 

http://www.acu-rite....70000487G_4.pdf

[daveb56]

Thanks Tim

I know the tapping cycle in the control but I'm trying to config. my post so I can do it with Mastercam X7 also.

 

Dave

[crazy^millman]

Dave that is a different question all together. When you searched the old topics which one was close enough to help you figure out how to customize your drilling cycles in the post?

 

HTH(Hope that Helps)

[daveb56]

I'm using a Fanuc 3X post. It has been modified so the drilling cycles work but can't get the rigid tapping cycle to output in inches per minute based on RPM and threads per inch.Posted feed rate for a 1/4 -20 thread is F.050 and it needs to be F10.0

Also the post is not putting in an M3 or M4 to start the spindle.

I'm also working with my Mastercam re seller but thought maybe someone here had the same problem.

 

THANKS

[crazy^millman]

I'm also working with my Mastercam re seller but thought maybe someone here had the same problem.

 

There sir is your best direction. BTW Welcome to the forum.