Rotating Backplot issue

[rrichard]

Morning everyone,

     If someone would have a couple of minutes to look at this MX8 zip file.

My issue is on the last two drill opts, the 1/8" and the 9/32" drills. These two are exactly the same as the other opts drilling, it's a simple canned drill cycle.

    When running backplot and verify, it's crashing into the part.

    But the post seems to be ok no crashes?  Can't figure out why these are the only two showing me this. I must have something wrong in my setup?

Thank you for your time.

Rotate.Z2G

[Guest]

Nope, what you see there is pretty normal for the way back plot processes the rotational moves.

 

Sometimes you can use larger retracts to make it look better, then switch them back once you know that's the issue

[rrichard]

Thank you JP, lil bit scary, hope I never get in to 5 axis

Later