Post issues with WCS

[civiceg]

I modified a mpmaster post for x8 a few months ago. When I creating my current file I had that post being my current machine. It posts just as it should however, when I go to repost using an older machine post it does not output a work coordinate. These "older" post are updated from V9.

 

[Guest]

When you are opening a V9 file, as the Machine & COntrol def did  not exist at that time, Mastercam will stick in a default machine.....

 

Change the machine def to your current one....

 

Also, double check your misc int's as they may not be the same as they were in your old file

[civiceg]

No old files just old post. Started off as a mcx8 file using my mp master x8 post. Post fine with correct work coordinates, go to switch to my x8 converted v9 post. No work coordinates output. I will try the misc integrers.

[civiceg]

Misc integrers did it, thanks, was loosing my mind.

[Guest]