Mastercam for Solidworks - Copy toolpath

[Lord Wukits]

Ok, so I've searched the forums, and have not seen anything.

Using Solidworks for Mastercam, I cannot seem to copy toolpaths without the mastercam add-in dragging in additional geometry, new start locations, and reversing direction(conventional/climb).

The tool path is contour and I right mouse button hold > drag to the bottom > release right mouse button > select "copy after"....

Is there a way to lock in the geometry used in the copied toolpath?





I gotta be honest I'm getting more and more disappointed every day.

[Ryan Butt CNC Software]

Dear Lord,

 

We are aware of this issue and are already looking into it.  D-19263. Also please feel free to contact us anytime with any questions, issues or requests you may have or are running into. 

 

For technical or "how to" related questions email us at [email protected]

To report a defect or to submit a request email us at [email protected]

[Lord Wukits]

Is that not what this forum is for?

[Ryan Butt CNC Software]

Actually no. This is a Mastercam "user" forum hosted by one of our resellars In-House Solutions. It's intended to give Mastercam users a place to bounce ideas, questions and issues off of each other. The forum is not moderated by CNC Software although some of us will pop on from time to time. To run an issue by CNC Software directly you would need to either send it in to one of the email addresses above or post it up on the Mastercam.com forum board.