Toolpaths / Solids in Operation Manager

[Scott Lent]

Greetings,

 

Up until about an hour ago, I'd always been able to toggle between Toolpaths and Solids by clicking on the corresponding tab at the bottom of the operations manager panel.

Suddenly, those tabs have disappeared and I have to click on 'View---> Toggle Toolpaths Manager' or 'View---> Toggle Solids Manager' to accomplish the same thing.

 

Can somebody tell me how I can get those tabs back?

 

 

Thanks in advance.

[BFleeger]

Have your Managers become minimized off the screen?  Look at the edge of your screen to see if Toolpaths and/or Solids is shown:

 

 

If it is there, hold your mouse over the words and the window should slide out.  Then if you click on the "Pushpin" in the top right of the

Manager window, it will "stick" it onto your screen again.

 

 

 

If it is not there, the View / Toggle Toolpath Manager    turns the window on and off for me (I am in X9 Update 3).

 

-Brian

[Scott Lent]

I apologize for not returning to this post until now. I'd sent an email to my reseller that evening and they responded the next morning. All set now.

 

Thanks.