Okuma OSP700L post help

[Sandybar]

when I do a canned cycle I get this when I post.

 

$T1.MIN%

O0001

G0 X10. Z10.

G50 S4200

G97 S1147 M03 M42

G0 X1.3317 Z.075 M08 T0101

G96 S400

NAT01 G81

G0 X1. Z.075

G1 Z-1.5

X1.1375

X1.2134 Z-1.525

X1.3317

G80

G85 NAT01 U.02 W.005 U.2 F.008 <----------Need this moved

G0 Z.075

 

I need to get this instead.

 

$T1.MIN%

O0001

G0 X10. Z10.

G50 S4200

G97 S1147 M03 M42

G0 X1.3317 Z.075 M08 T0101

G96 S400

NAT01 G81

G85 NAT01 U.02 W.005 U.2 F.008 <------------To Here

G0 X1. Z.075

G1 Z-1.5

X1.1375

X1.2134 Z-1.525

X1.3317

G80

G0 Z.075

[Greg Williams]

Are you experienced at editing posts? If no get your dealer to do it. If yes then start with the prcc_call_end block

[Sandybar]

I've done some minor post tweaking but looks as if this is more than I can chew off. I contacted my re-sellar.

 

Thanks