Hybrid toolpath question

[wayne4352]

How do I get a hybrid tool path to act like the old blend tool path. The blend was great for doing parts like these. I need the tool to start on the inner boundary and go up the inside angle then across the top and down the outside angle. Its the only way to keep this material burr free and sharp on top. The step over will be much smaller. I had to increase it so the file was small enough to upload

test.mcx-9

[Guest]

I don't think you'll get Hybrid to act like Blend....

 

The Hybrid path is a basic combination of the Waterline & Scallop tool paths.....no really conducive to getting the kind of motion you're looking to achieve

 

Surface Finish Blend is still available, right click in your OP's Manager >> Mill Toolpaths >> Surface Finish Blend

[wayne4352]

Thanks. Worked great.