Heidenhain Post

[dude]

Hi Could that pst. sork for a bridgeport with heidenhain 341 ?  I tried to find the post but no luck.

Best regards

[Guest]

1 minute ago, dude said:

Hi Could that pst. sork for a bridgeport with heidenhain 341 ?  I tried to find the post but no luck.

Best regards

Contact your reseller, asking for a post here is a no-no

[dude]

Just now, JParis said:

Contact your reseller, asking for a post here is a no-no

Sorry but if you check what the others posted didnt they talk about posts ?

[Guest]

6 minutes ago, dude said:

Sorry but if you check what the others posted didnt they talk about posts ?

Talk is fine, you're asking for a post, that is NOT fine

 

from the Forum Guidleines

• eMastercam.com is not the place to ask for a post processor. If you need post work done, please see this wiki entry.

Edited August 14, 2018 by Guest

[pullo]

-.The 530 does not need to be drip fed .  You need TNC remo , free software from Heidenhain and you can use a network cable .

- The best post I have seen that comes from CNC Soft is called Generic Heidenhain_TNC530 3X mill . Ask your dealer for that.

- Don't even look in the ISO direction with Heidenhain.  

- I don't have OCD , but N10 L M6 is silly on a Heidenhain . It can read N10 M6.  If you wish to write that on the control (e.g. in the MDI ) , you don't start a line with the L button. you 

start it by pressing the orange X , Y or Z button , then press the No ENT and the coordinate letter will disappear. Then use the right arrow to get to the M letter....

- Your Heidenhain guy won't help with Mastercam ,  the other direction is possible  

- it is very seldom that the 530 is set up to need M6 . ...  If you want it gone , there is a parameter for getting rid of that .

 

Gracjan