I  AM LIVING IN USA

Hi team!

I have 3 Okuma M560-V need to make the right angle head block. But I don't have the spindle face  holes dimension.

Would any one please help me to get it. I try to many ways but I can't  get it.

Thanks so much. 

Hi Jake!

It is wonderful instruction !

I got them all and  run  the RAH on YCM  machine. It was com out very beautiful.

Thank you so much.

Hi Jake!

This is the 1st time I run  RAH drilling on this YCM vertical machine. The milling in G19 mode is ok, only canned cycle drilling in G19 mode does run right.

I don't known about the parameter changing.

would you  please help?

Thank  you so much Jake. I found the Parameter in the book, but I can not  change it. Do you think that I need to contact the seller to change it.

Thank for your help.

Hi Jake!

This is the 1st time I run  RAH drilling on this YCM vertical machine. The milling in G19 mode is ok, only canned cycle drilling in G19 mode does run right.

I don't known about the parameter changing.

would you  please help?

Hi

I post  RAH drilling  program to NC with MPROUTER.pst

My machine is YCM -Fanuc control

G19 G20 G90 G40 G80 G64 G49 G0 M05
G8 P1
G90 M05 Z0
G52 X0. Y0. Z0.
T40 M6
G0 G90 X-5.7348 Y2. C0.
S50 M3
G43 H40 Z0.
G1 Z-1.949 F500.
G19 G98 G83 X-7.8348 R-7.2348 Q.05 F20.
Y-2. X-7.8348
Z-3.901 X-7.8348
Y2. X-7.8348
G80
X-5.7348 F500.
Z0.
G90 G49 Z0. M05
G52 X0. Y0. Z0.
G8 P0
G17
M30
%

on line  G19 G98 G83 X-7.8348 R-7.2348 Q.05 F20.

it  work doesn't  right, the drill move in like rapid and stay in there and move to another location.

when I run on the air 0, It drill on Z axis, not on X axis.

Any one please help for advise

thanks

Hi! would you please help me to edit the  HASS TR310 5AXIS POST to get the sub program.

I see in the post  that the subprogram in not enable.

thanks

HOW DO I GET POST FOR MAKINO D500 5AXIS?

THANKS