I have the task to buy used OD/Id grinder, any help is going to be appreciated, has to be for 8'' diameter part and length about 14''. Thanks for any help.

solo as la pregunta y seguramente alguien te ayudara

Because It is only cutting one set of geometry, It works when you have multiple set of geometry.

Thanks a lot for you help. you give me idea what to do.

I am using Mastercam MIll X and I updated the post from mastecam 9.I am not using job set up.When I posting from Mastercam V9 give a error(illegal character $ on left side of equation, post line number 70, program execution halted due to error in .pst.That problem that I have When I posted from Mastercam X the feed rate is very slow and will not output Feedrate.

Can any one point me in the right direction? my anilam 1100m post will not output Feedrate Thanks in advanced

I know, this has been covered numerous times, in fact it has been covered so many times, I don't know where to start, so I thought I would ask you forum members for help that I can pass on to our systems manager. We are looking to purchase a new computer system to run Mastercam and solidworks exclusively. Any comments or suggestions would be appreciated?. The boss asked me to find out what works well with mastercam and Solidworks only.

Thank for yur answer!. I been doing like jeff sey.But I thought it was a easiest way to doit.According the Mastercam Support,biginning with version 9, Mastercam has the ability to convert from metric to English or vice versa by typing in "mm" after tha number.

Hi guys! i'm having trouble to convert metric to inch on the fly.I type in "mm" after the number and the number doesn't convert to the opposite value. I'm using Mastercam 9.1 MR0304