Struggling to get exactly what I want for this contour. I'm cutting a countersink for a 5/16 clearance hole in stainless steel(.332 D at the bottom & .635 D at the top). I'm cutting the clearance hole first and then countersinking. I've experimented with different 3D tool paths and found that contour works best for what I'm doing since it allows you to arc filter and and cut from the bottom up. The step up is set at .015 and ideally I want the tool path to have a radius at each step up so the code isn't so long. Anyone know of a better way to set up the arc filter or a better toolpath? Thanks!

Thanks for the reply Tried That, it still has the same issue.

When verifying operations in Mastercam 2021 the output graphics are blurry while running the verify. When the operation is complete or I complete the verify the output is correct, the graphics are only blurry while running the operation. I have The simulator engine set to 5-axis and my computers hardware is the recommended hardware to run the software. The picture shows the problem, hopefully someone has a solution. Thanks in advance