I figured out what the problem was. I feel dumb now. I was running Mastercam X MR2. I thought it was X2, so I installed X2 this morning, and it is working great now. Thanks for all the help.

I am running XP I might try to do a clean install.

I tried to do this via the Mastercam X Control Panel applet, and I get the following error. The operating system cannot run %1

I just tried this again, and it says that either the file was created in a newer version of mastercam than I am running, or mastercam does not recognize this file type. It is a .SFB file

I keep getting the following error, Error 1628: Failed to complete installation. I had MasterCam shut down, and turned off my virus protection.

How do you re-register it? I am running XP. I did a search, but nothing cought my eye. Thanks

I have recently upgraded to SolidWorks 2007, and I am not unable to open SoildWorks files in Mastercam. I have X2 installed. I was able to open SoildWorks files when I had SW 2006, and Mastercam X. I have downloaded the mastercam direct, and tried it, but it still will not work. When I try to open a SW file in MCX, it says there is no parasolid data available. Thank you for your help, Kirk Pedley

There is no option in SolidWorks. The reason being, I do not have Mastercam on my machine, only SolidWorks. I will try the first option. Thanks

I am trying to use the mastercam direct add-in, and it saves the file out as a.SFB file. I then go to Mastercam to open the file, and it says it cannot recognize the file. I have SolidWorks 2006, & Mastercam X

I have SolidWorks 2006, and have the Mastercam Direct add-in. Now when I save as a .SFB file my Mastercam will not open this. is Mastercam Solids required for this?

We are using SolidWorks 2006 now, and also have Mastercam X. Just wondering what kind of usable geometery you get when you import SW files. Thanks

Jimmy hooked me up. Thanks Jimmy

I am trying to send my program to my machine and cannot figure out how to do this. I can post just fine, and save the file, but I cannot find where to send the .NC file to the machine?