Hi all, Finally we found the responsible for pc hard locks: it was the keyboard. A very cheap USB keyboard was definitely not compatible with our motherboard. HASP usb key was cleared of accusations. Bye Thanks you all folks

Hi folks, We're experiencing frequent hard lock of the workstation running Mastercam 9. Does it exist an incompatibility between USB HASP and Asus P5N32-E SLI motherboard+PNY Quadro FX1500? Thanks

Thanks a lot to all of you folks, We apreciate very much your suggestions. Bye

Hi folks, I would like to know what's the best hardware combination to run mastercam X2. Our main interest is creation of complex surfaces 3d toolpath. The target is reduce the wait for nc calculation. Thanks Bye

Thanks to you all guys, I'd like to have a direct impression of the makino S33 from users already working with bye

Hi The workshop I work for is thinking about buying a new vertical machining center, a Makino S33. 1) Is in your opinion mastercam 9 or X a good cam choice for this machine? 2) Is S33 better suited to moldmaking (our main job)or do you folks out there suggest other models from makino? Thanks in advance for your suggestions Bye