Jerry F McCarthy
-
Posts
6 -
Joined
-
Last visited
Never
Jerry F McCarthy's Achievements
Newbie (1/14)
0
Reputation
-
Thank You ! I will let you know how I make out
-
Is it possible to unfold a bent part in Mastercam to figure out the flat length before machining?
-
Is it possible to unfold a bent part in Mastercam to figure out the flat length before machining
-
create point problem
Jerry F McCarthy replied to Rick Henrickson The Boeing Co.'s topic in Industrial Forum
Thanks Thad I have had 8hrs min training on this software It is similar to Esprit that I run I believe the Mastercam is more powerfull I have a step file up and I could not get the right depths because the zero was in ctr of casting. Thanks again and wish me luck -
Anyone have a Haas VFss series mill? comments on them?
Jerry F McCarthy replied to Wally J's topic in Industrial Forum
We have 3 Haas VF3 and a Matsuura 510 tiger the Haas machines have been a real asset for 7 yrs with min down time only one has had major rebuild we run them hard and mostly aluminum 6061 t6 2 shifts Good machines Short money -
create point problem
Jerry F McCarthy replied to Rick Henrickson The Boeing Co.'s topic in Industrial Forum
Gentlemen I have a casting, point of origin is in the center I am machining a mock up version with draft angles I have the bounding box but I cannot move the origin point to upper left corner even in machine set up it shows it has moved but f9 show it in center