Thanks for your input John.

We just started using X2MR1 and the post isn't working properly, it was fine using X2 before the upgrade. Now it outputs 2 G91's on 1 line, there isn't a M3 or spindle speed. Also the config files are read only, how are we to make changes if needed? Is this designed this way or do we have a problem with the software? thanks, Darren mill3 X2MR1

John, Perfect! Thanks for your quick response. I haven't seen the old Pats logo in a long. Cool! Darren

I'm looking to change the defauts to the job set up file. Can the job setup file be changed throught the screen, configure file or does it have to be reset up for every job. Also, I need to slow down the feed rates in the corners of pockets to half of the programmed feed. Is going to the "chain manager" and "change at point" the only way to do this? Does X2 offer any options that V9.1 doesn't? We are using V9.1 MR0105 and we have X2 (we haven't made the switch yet). Thanks for your help