Hello I noticed today when drip feeding a small peck drill program that the canned part of the conversational program was not being seen by the controler it is moving to the hole locations. It's being sent ok but it's not working (pecking). Is there any settings in the Cimco Edit transmission that I should be looking at??

Yes I am using X3MU1, I did turn off the arc filter and everything is ok now...Thanks for your help....this forum is great.

Has anyone had problems with parallel finish? I had one today with a zigzag method(gap broken method) the path did a partial circle before it stepped over. I changed the gap motion to smooth then it was ok. Tried the same toolpath in X2 setup the same way (gap broken method) and it was fine.

Hello I would like some help changing a post I use, the machine is a large bridge mill without a toolchanger. I would like to remove all toolchange information and a G91 G28 X0 Y0 at the end of the program as below. N100 G21 N110 G0 G17 G40 G49 G80 G90 N120 T5 M6 N130 G0 G90 G54 X31.304 Y-3.236 S1909 M3 N140 G43 H5 Z50. N150 Z10. N160 G1 Z0. F15. N170 G2 I-55. J0. F763.6 N180 G1 Z10. F15. N190 G0 Z50. N200 M5 N210 G91 G28 Z0. N220 G28 X0. Y0. N230 M30 % TO N100 G21 N110 G0 G17 G40 G49 G80 G90 N130 G0 G90 G54 X31.304 Y-3.236 S1909 M3 N140 G43 H5 Z50. N150 Z10. N160 G1 Z0. F15. N170 G2 I-55. J0. F763.6 N180 G1 Z10. F15. N190 G0 Z50. N210 G91 G28 Z0. N220 X0. Y0. N230 M30 %