hancast
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by hancast
-
Has anyone else been having the working plane change in 2020? I have had multiple times where all of a sudden my active plane is not the one I was working in.
-
I print a lot of layouts in mastercam to full scale. In X9 the print module was great but in the new version I'm having trouble getting a true full scale printout. I went into the settings and set to 100%. Anyone else having trouble with this?
-
Is there a way to get the create curves on surface edges to recognize arcs better. Everytime I do I check the fit arcs and lines, but I still end up with a lot of spline and arc combinations when it looks like it should make a complete arc.
-
I knew there had to be an easier way, Thanks.
-
I think it would be good if there was a choice of selecting all remaining surfaces, after picking drive sufaces. I think it would change alot of time.
-
Is there a way to select all the remaining surfaces that were not drive surfaces when you go to pick the check surfaces?
-
I have a drawing I am trying this with and when I window select an area it asks me to select a start point and then it asks to pick the first chain. It doesn't select the chains automatically.
-
Does anyone know how to select wireframe geometry by depth? I have a lot of profiles that lie on the same depth and it would be easy to select them by that.