hancast
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by hancast
-
-
I print a lot of layouts in mastercam to full scale. In X9 the print module was great but in the new version I'm having trouble getting a true full scale printout. I went into the settings and set to 100%. Anyone else having trouble with this?
-
Is there a way to get the create curves on surface edges to recognize arcs better. Everytime I do I check the fit arcs and lines, but I still end up with a lot of spline and arc combinations when it looks like it should make a complete arc.
-
I knew there had to be an easier way, Thanks.
-
I think it would be good if there was a choice of selecting all remaining surfaces, after picking drive sufaces. I think it would change alot of time.
-
Is there a way to select all the remaining surfaces that were not drive surfaces when you go to pick the check surfaces?
-
I have a drawing I am trying this with and when I window select an area it asks me to select a start point and then it asks to pick the first chain. It doesn't select the chains automatically.
-
Does anyone know how to select wireframe geometry by depth? I have a lot of profiles that lie on the same depth and it would be easy to select them by that.
plane jumping in 2020
in Industrial Forum
Posted
Has anyone else been having the working plane change in 2020? I have had multiple times where all of a sudden my active plane is not the one I was working in.