Yup, I've tried this as well. I've also drawn 3 points on the face plane corners I want translated (to top), to no avail the cursor doesn't see anything. Even when I lock on cursor point, I cannot click these 3 points I've just created, when prompted to.

Thanks for the reply! I also tried dynamic, same thing, as it will not allow me to anchor the gnomes to anything on the part, to try rotation. It's also difficult to accurately set the part planes using Dynamic, when the file comes in with all axis of the part in different unknown angles. This is where 3 point or face options shined. Perhaps this is a 2023 version bug, I've not experienced this previously. Inhouse could advise.?

Good day all, been 16 years since I fired up this account. Hope you are all well. I hope I'm in the right area to ask this question. When a part is imported into 2023 Mastercam in an isometric type view, (just the way we receive some files x.t), I would always use Translate to plane and in the "Source plane" function area, I would choose 3 points and click the places on the flat plane, of the part, that I would like to have translated to the Destination plane "Top" view. Then Having one face of the part set on a flat plane , I could rotate the geometry, and set origin. Usually easy. The issue that we are having here is, When prompted back to the part on the screen to choose anything,( flat plane, line, 3 points, dynamic... Nothing works. The cursor recognizes nothing on the part, like its not there, not allowing me to pick any geometry. I have opened a few other files and the same thing occurs. Its like those functions are turned off. Any input here would be greatly appreciated. Thanks