Thanks so much guys that was fast too! this form is the greatest Hope i can return the favor someday

hey, posted a file arc help on the ftp site ftp://mastercam:[email protected]/ARC_help.MCX Im wanting to blend the two long arcs together with the arcs at the ends but they all ways end up flat anyone that can put into words how to do this it will be greatly appreciated

I have but before i did anything I wanted some opinions on witch ones talked about it the most the last training i got said they talked about it but it was very bref so i didnt want to do that again thanks

wanting to learn complex 3d surfaces and tool paths and the geometry it takes to make the models! that part seems to be left out a lot what online, cd, or book training resource do you think covers this the best

I have saved it in .dxf format and its not working for me? after i trace an image I delete every thing but the path then save as dxf. but it wont open in mc

Anyone use files from Inkscape in mastercam I can't get mc to open them even when I save them in known suported files?

When I print the file as a pdf and then print it from the pdf and the measurement legend if it shows 2 inches it does not measure 2 inches? I have played with the the two boxes where you can change the scaleing of the part and the legend and haven't got it to come out right yet am I in the right spot or do i fix this some where else?

opps I mean thanks a lot guys!

ok thanks a lot guy

When your drafting and you change a measurement is there any way to update the geometry according to your drafting?