hsmith133
-
Posts
6 -
Joined
-
Last visited
Never
hsmith133's Achievements
Newbie (1/14)
0
Reputation
-
Is the editor capable of transforming a block of code by the X, Y,or Z values? Had a simple change to a couple of hundred lines of code in the program, change all Z values by +.100. Could not figure it out. We are running Mastercam X.
-
Editor overwrites existing file if more than one session is open at a time. Would like to have two programs open at a time. thanks-harry
-
How about a plunge point on a closed inside contour. Making a rough pass in steel, stop and remove slug? Doesn't seem to work too well. Again-thanks
-
Thank you.
-
Cannot seem to figure out how to plunges at a existing point for a pocket?
-
My first post, hello. We are running Mastercam X Is there an easy way to switch the part material setting after a tool path is done? thanks-harry