Good Day Rdgould, Welcome to the forum. Are you looking to run one time with sheets on top of each other? I'm not sure I understand?

Well.................it seems to work better if the super control is on!!! Thank you everyone for you help and support.

Today I am able to check a couple of things - will keep everyone informed.

If anyone is familar with this please advise. [The drive or network connection that the shortcut 'DATA on Thermwood.lnk' refers to is unavailable. Make sure that the disk is properly inserted or the network resource is available and then try again.] Thank you and I will appreciate all feedback.

Thank you, that is very nice of you. I will email the file to you.

Thank you PeterM. This helps me greatly.

I am using Mastercam Router 8.1.1 and still trying to see if my update procedure has updated.

I checked my sheet margin and I am only using a .5" margin. I believe my parts should still fit on this sheet. (oh boy)

Is there a way to see or even confirm that your software has been updated after completing an update?

Salutations! I am working with Version 8.1 Router. The problem I am having is that I am unable to nest all of my required chained items. For example, I am trying to nest 10 doors, all with the same profile just different sizes in width and height. When I proceed to have mastercam nest, it will only nest 6 or even up to 8 doors. I have yet to have all of the 10 doors nested. I am able to manually nest all the doors on one standard sheet size but my software has not. Any ideas?