mfilleti
-
Posts
7 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by mfilleti
-
I am trying to do a boolean add on 2 solids. After I select my two bodies I get a warning that says I have a parasolid kernel interface error, boolean error, operation would result in a non-manifold body. I've checked both solids and can't figure out what my problem is. Does anyone have any insights? Thanks Matt
-
using a mathematical formula to draw geometry
mfilleti replied to mfilleti's topic in Industrial Forum
thanks for the help. Between the engineer and myself we figured it out with your help Allan! Thank goodness for the internet and people like yourself. Everything is so much quicker, easier, and efficient. How did people ever get so far in the past? That is all Matt -
I have a job that requires a curve to be machined out as smoothly as possible on the mill. The curve was formed by a formula. I was wondering if I can input the formula into ver 9.0 somehow, and use the software to produce the curve; rather than me inputing x and y co-ordinates every half millimeter and joining the dots.
-
thanks for the help everyone. Matt
-
I just started using solids v9 and I only have a tutorial book. It doesn't mention anthing about ploting. When I plot a solid drawing it only prints the wireframe. Is there any way to see the surfaces as they are shown on the screen? That is all Matt
-
Thanks for the prompt replies. I'm progressing nicely now! Matt
-
I'm having a hard time trimming a flat surface to a curve or to a surface. I keep getting the "cannot trim surface, selected curves do not form a closed boundary" message. I've tried extending the two surfaces until they extend beyond eachother before trimming, but I still have had no luck. Any suggestions. That is all Matt