Thanks Hardmill

I wiil do some file comparison with may older post

The general setting are different for sure and will check the rest

Good morning all I have a simple question about changing a post to add a tool list to the header of my programs,

The rep was by last week and helped the mill guy's with a problem and did this for the mill post. So of course I needed it for the Lathes x14

Found the part in gen setting to change this but changing it made things worse

of course I did not change the oring.post so back to it I went.

Is there a easy # change or do I need to get the book.

Thanks Brad

Good morning all I have a simple question about changing a post to add a tool list to the header of my programs,

The rep was by last week and helped the mill guy's with a problem and did this for the mill post. So of course I needed it for the Lathes x14

Found the part in gen setting to change this but changing it made things worse

of course I did not change the oring.post so back to it I went.

Is there a easy # change or do I need to get the book.

Thanks Brad