Thank you, Gcode for help it work again.

My company comp use to be running on nethasp ( X6 ) I move to a new building with out network and my supervisor give me a dongle. I plug them in but mastercam just said hasp not found. How can I disable nethasp and use hasp instead? Thank you

Come up to real pain by replace mmd in every single file I have created working every time. Thank you, everyone for help.

Thank you, gcode I use chook to update post , but I can not check machine def and control def to update in chook. and by the way mastercam start up guide told me to use update folder to update control and machine def after I follow step by step and i'm triple check that everything go to correct folder they still not compatible with post.

Company upgrade from X6 hasp to X7 nethasp. Step by step post update by chook is OK no error, update machine and control def by using update folder is no error log, but when I 'm posting ( any ) I have an error massage " Machine def and control def are not compatible with post " ( Thermwood 3 axis machine ). How ? Thank you,

The company I work with is cutting honeycomb panel for commercial aircraft. We use router ( Thermwood ) and Mastercam mill to do a job. The result is not bad but we try to seek a new way to improve. Then my manager came up with idea about ultrasonic cutting machine may do the trick. Is that will be possible? Thank you.

Thank you Aaron, Another question come up in my mind " how many time you can use update post to update from previous version since I read at my company post it's have been create for version 9 and some one update and use for X4 but can't update to X7 which are tricker for fault alarm." Thank you

Hi, i'm new to mastercam how can I update machine def, control def and post from X4 to X7, I try to use oudate post got error too many lines in a post. Thank you.