Scott Sizemore
-
Posts
135 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by Scott Sizemore
-
-
jagourley,
I am about 30 miles north of FT.Wayne about five miles from Albion. Got any good tips for the HSM software.
-
Randy,
Didn't take to long to figure out who scott333 was. By the way this is working out very well for us.
-
Got it here to! Completely awesome.
-
Turn on your rapid retract switch.
-
Change your Mill.set to Mill.pst then select Mill.pst just like if your were posting an NC file. It will then bring your set-up sheet up in your file editor just like an NC file would.
-
I have the same problem. I changed my mill.set to mill.pst and posted the setup sheet that way then it was just fine.
-
I've had this problem before to. It seems like to fix it I would select all the operations and change there NCI destination and the problem went away.
-
Try using create, curve, project and project your curves on your surface and use a 3d contour pass.
That will give you the ability to control your depth and depth of cuts.
-
Ever try G98 instead of G99?
-
When is Mastercam-X coming?
[ 12-12-2002, 04:57 PM: Message edited by: scott333 ]
O/T Kia Lathes
in Industrial Forum
Posted
We currently run Okuma lathes but, we are lookin at a Kia Super Turn 28LM because of the price and travel. Any one ever been around one of these.