Bump up. No feedback from anyone, c'mon guys!

Ok, here's the deal. I've usually had no issue connecting through Cisco Anyconnect to my nethasp server, specified by address in the .ini file. Neither my remote machine nor the server have an active firewall. This seems to be an intermittent issue, as it doesn't happen all the time. I should point out that I can contact the nethasp directly and it shows the license. I also can ping the server and get good replies. For some reason when opening MX6 though, it will not find the sim. I've also tried bumping up the timeout parameters in the .ini to 10 seconds with no avail. Any suggestions?

Dave, Hey, this is Ryan from CWST in E Windsor. You know, I dug a little more and found this (attached) I primarily use parallel to multiple curves, as it solves most of our motion requirements. I do know the parameter you speak of in Curve 5 Axis. When I was talking to Tyler a few weeks back he mentioned there is a place where you can alter the parameter. I believe this might be it. What do you think? Haha, speak of the devil.

Nice! Hey Jon. I didn't know you guys were on here. I'm trying to change the simulation axis on backplot. Right now it rotates about X and I want to change it to Z. I looked in the toolpath parameters under axis combination, at the bottom of the tree, and this is what I'm seeing. (Attached) Is this where you are talking about? Unfortunately it's all grayed out.

Hey guys, I'm new here. Just to give a little background, I've been using Mastercam for the past couple of years but not for the traditional "machining" purposes it was designed around. Instead I use Robotmaster add in for 7 axes robots in the thermal spray industry. So my question is pretty simple but I cant seem to find what I'm looking for. In backplot you can simulate rotary on an axis. Where is the setting to change the axis you would like to rotate around? Any help would be appreciated.