Ya I'm not familiar with Vericut

Ya the minimum retract was selected. why would that not show a crash though in verify. I scraped a $1000 BECAUSE OF IT! It makes no sense. Thanks guyinthedesert

so are there any requirements machine or system wise in order to utilize the high speed toolpaths

I can shot an email.

ok I will try again to add the file. its at 9000+k I cant up load

ok I will try again to add the file. its at 9000+k I cant up load

no it doesn't have dogleg as far as I know they are older okumas particulary evs 4020 with mac man

yep

from what I can see the tool must not have come to the specified height before it move across the part.

Well I just found a new one. running a surface high speed core roughing pass. Everything looked great on verify starts running everything sounds good, start finish pass then notice more than a dozen corners have been taken out with the roughing pass. Can anyone help, this was not showing on the verify.

I had the same issue yesterday, Mastercam came back with turning off smoothing in your total tolerance option. and they are working on fixing the bug

as far as I know yes. I also contacted the local software retailer as well. fill ya in on what they find out

Well yesterday before I installed the mu1 it would render tool paths with no problems and with no crash issues. And for whatever reason regenerating tool paths is excruciatingly slow.

I'm having a problem with the update. Everytime I render an endmill pass, it blows threw the walls of my part any help here